1Table of Contents Getting Started 2 The Basics 2 Setup steps and AT-Commands 2 Host AT-Commands and setting up the Host 3 Generic Strings 3 Cou
10 N Remote Control Mode O Force ANALOG Mode: ON This is only for testing DO NOT LEAVE ON P Exit to Terminal Mode Battery voltage: 13.
11COMPRESSION... V42Bis Line QUALITY... 006 Rx LEVEL... 022 Highest Rx State... 00 Highest TX St
12t+ms=10,1 OK at+ms? 10,1,1200,2400,0,0,33600 OK at&w OK at\n5)m1 OK at&w OK RING RING RING ata CARRIER 2400 PROTOCOL: ALT COMPRESSION
13ZOOM V.92 Lucent chipset Firmware = Zoom V.92 Serial #s 1117d00 -C Z207 Landline to 9022A stationary Modem with maximum signal = 31 ATI11 In
14 Description Status --------------- ------------ Last Connection V32
15Highest Rx State... 00 Highest TX State... 00 EQM Sum... 0000 RBS Pattern... FF Rate Drop...
16 Voice Mode for the CDS-9022A and CDS-9052 Cellular Modems Using voice mode requires DataRemote headset model DRH-HDST for proper operation. To i
Important Notice Because of the nature of wireless communications, transmission and reception of data can never be guaranteed. Data may be delayed, c
2 Getting started, and understanding how the analog modem in the CDS-9022A CDMA and Analog Modem works. This User Guide is an addendum to the CDS-902
3only powers the Analog modem up for 20 seconds after the last keystroke. When programming or making changes to the program, make sure you store the
4 Suggested AT-STRING for the host modem calling a CDS-9022A Modem for a V.32 connection AT&F;+MS=V32,1,4800,9600,4800,9600;-SEC=1,12;)M1;\N5;&am
5 Default AT-STRING for CDS-9022A Modem setup Note: This command string is for V.32 4800bps to 9600bps AT&F;+MS=V32,1,4800,9600,4800,9600;- SEC=
6 D6 = ON Analog Mode - CDS-9022A is in analog mode. (*) Command is only used for testing Outbound calls from the CDS-9022A Refer to CDS-902X Us
7AT-SEC=n Enable/Disable MNP10-EC Enables or disables MNP10-EC operation. The command format is: AT-SEC=n, [<tx level>] where <tx level>
8ATQn Quiet Results Codes Control This command enables or disables the sending of result codes to the DTE according to the parameter supplied. Th
9This should not be necessary in most cases, but, there are some 2400bps, 1200bps, or even 9600bps modems you may not be able to connect to without u
Comments to this Manuals